Method 2 - without using a Computer to merge you just need to make them available via the “In ‘All MIDI Inputs’” column. You can have as many external controllers as you can connect to your computer. Set the MIDI Out channel to merge all Track data to the selected Channel. If you set the target to MONTAGE Port 3, it will reach the device connected to the 5-pin MIDI Out. If you set the target (MIDI Out) of the Track to MONTAGE Port 1, it will reach the MONTAGE Tone Generator. This will allow all of the devices you marked as a MIDI Input to act as controller to the target (MIDI OUT) device, when the Track is active.
Next, create a MIDI Track and set the MIDI IN to “All MIDI Inputs”.
If it is setup as a MIDI Input you can route it wherever you need. _Connect any other device you wish to merge to the computer via its own connection. Data will be echoed back thru the MONTAGE acting as Midi Interface. MONTAGE Port 3 allows you to connect a MIDI controller thru the 5-pin MIDI jack on the MONTAGE back panel. (Do not mark Port 2 -it is used expressly for Remote Control). _To make the MONTAGE a MIDI Input device, place an ‘x’ next to MONTAGE Port 1, if you want to merge a second controller thru MONTAGE also place a mark next to MONTAGE Port 3. In the column labeled “In ‘All MIDI Inputs’” place a mark next to each device (Controller) you wish to use as an input device to a Cubase MIDI Track. In a DAW, like Cubase, go to STUDIO > STUDIO SETUP. if you mean to the MONTAGE, no.īut here is how you can (and always could) connect multiple controllers to the MONTAGE.Ĭonnect your MONTAGE to your computer using the USB “To Host” port and install the Yamaha Steinberg USB Driver.
New in version 3.00 you can connect a MIDI Controller that only has USB for MIDI to the MONTAGE “To Device” port, specifically.Ĭan we connect two midi controller using usb hub?. In os 3.0 we can connect midi contoller to montage through usb port.
0 kommentar(er)
